One question
I have the logo on the screen so the sytem is booting but I don't arrive in pre-boot mode to reflash.
I think that i don't used the correct boot.ini .
In this case there is one way to reflash the system ?
First time I think that Garmin flash the processor directly on the board or not ?
19th February 2013, 07:53 AM
kunix
Usually all the stuff you need to recover (x-loader, bootloader, firmware) is contained in NAND or NOR chip in the PCB, not inside the processor.
If you could unsolder that chip and send me a few first megabytes of dump, then I would be able to give you advice what to do.
19th February 2013, 08:41 AM
jpnos
Ok
I just check what chip there are on the pcb .
7th September 2017, 11:15 AM
ganyak
I have the same board and the problem is that i system is loading with repeated in loop messages LOADER LOADING , LOADER, SOFTWARE LOADING and SYSTEM SOFTWARE MISSING.
Putting in PREBOOT mode does not changes anything. Garmin Cure doesn't help and ends with error.
I could put BOOT.bin to LOADER.exe, but when i am putting FW_ALL.bin process is starting but i am getting an error at up to 70% of the process (different number every time, depends of starting time).
Can anybody help to fix that problem?
As i see, there is the place for two additional connector. Possible for serial port and SDIO interface.