Anybody can help me on my nuvi. i cannot enter USB mode when plug in to usb. it will always switch on like plugged in to power supply. damn... i dont understand what happend.
If you have an sd card in the nuvi take it out and try.
'Thanking Posts' are banned. To thank someone, and/or to see hidden links and content, use the [Only registered and activated users can see links. ] button below left of the helpful post then refresh your browser [F5 key]. 'Thanking Posts' are banned.
Please don't spam. Posts serving no purpose other than to thank or to ask about hidden links are trashed or deleted, it's GPSPower's policy. Please don't spam.
[Only registered and activated users can see links. ] should make their first post as a new Intro Thread in [Only registered and activated users can see links. ].
Moved to a new thread, coz it was off topic in Garmin cure one.
Look at pins, may be one is damaged
everything was fine,the pin, the drivers updated, but still cannot go to usb mode.
if driver installed, the hw driver detection should not start ... please confirm
- plugin the usb cable ti would go like charging mode
- remove usb cable, it would tell counting down and power off
- plug in usb cable again, it should jump to usb mass storage mode
if still not, seem your usb port or usb cable may the issue.
have you tried "another computer" ?
have you tried "another cable" ?
Maybe you using a "charging cable" that is resistor enabled !!
Have you tried "pre-boot mode" ?
Go to hidden menu over battery icon and look beside USB what is writen.
Do you have 500mA or do you have 1A?
If you have 500mA then something is wrong with your pc if you have 1A then something is wrong with your cable.
Do you have cable like this beside number 1 or 2:
[Only registered and activated users can see links. ]