As for me, I think the flash is damaged.
Obviously a serious corruption, perhaps flash is damaged.
You could try to erase region 48 with sd command ergn and then re-try formatting, but best to wait first for advice from software experts - kunix et al..
'Thanking Posts' are banned. To thank someone, and/or to see hidden links and content, use the [Only registered and activated users can see links. ] button below left of the helpful post then refresh your browser [F5 key]. 'Thanking Posts' are banned.
Please don't spam. Posts serving no purpose other than to thank or to ask about hidden links are trashed or deleted, it's GPSPower's policy. Please don't spam.
[Only registered and activated users can see links. ] should make their first post as a new Intro Thread in [Only registered and activated users can see links. ].
As for me, I think the flash is damaged.
Hello, flash is damaged 70-80%. Game over
Last edited by macakbl; 3rd December 2015 at 12:43 PM. Reason: additional picture
not is operative for colorado 300 nor for etrex 20 and 30, because they continue to bricked, says "Loader" but it hangs it not advance more
Somebody can help me to unbrick a colorado 300? Thanks
Last edited by smokefree; 9th December 2015 at 12:37 AM. Reason: Merged two consecutive posts
Hi all of you My garmin 1490 can not go system i did try this Quick cure everything was ok but when Ever i Power My garmin is only writing garmin on screen some one can help me please wish you all of you have nice year
You posted the same issue in another thread, now split off into a separate thread here: [Only registered and activated users can see links. ]
Please don't cross post!
Last edited by smokefree; 27th December 2015 at 09:45 AM.
Have you now reformatted and then flashed the original firmware? Cure firmware CANNOT boot, it's only to allow access in Mass Storage Mode to remove corrupt files and/or reformat. See the initial post:
Please post ONLY in ONE thread as noted by smokefree above. This thread: [Only registered and activated users can see links. ] Only in there please.
'Thanking Posts' are banned. To thank someone, and/or to see hidden links and content, use the [Only registered and activated users can see links. ] button below left of the helpful post then refresh your browser [F5 key]. 'Thanking Posts' are banned.
Please don't spam. Posts serving no purpose other than to thank or to ask about hidden links are trashed or deleted, it's GPSPower's policy. Please don't spam.
[Only registered and activated users can see links. ] should make their first post as a new Intro Thread in [Only registered and activated users can see links. ].
Ok Kunix, heal tested on Garmin BMW Motorrad Navigator V, successfully. Thank you very much.
Last edited by Johnbr; 28th March 2016 at 11:25 PM.
Hey everyone. I hope I'm posting this in the right place. I have a nuvi 2598LMTHD, firmware version 510, HWID 1582.
The other day I went to update it with Garmin Express, as I hadn't done so in a while. I plugged it into PC, it was detected immediately like usual, and Garmin Express said there were both map and firmware updates. I installed the map updates and then began installing the firmware update. At some point during the firmware update, it asked me to disconnect and reboot the GPS. After I did that, my computer was no longer detecting the GPS. I'm pretty sure one or more files were corrupted somehow.
I've managed to flash it with the cure firmware, the computer started detecting it again and I could see the device files in explorer. I don't know which files are corrupt so I was going to format it with RMPrepUSB. This is where I'm running into trouble. For some reason it's being assigned 2 drive letters. E (1.80 GB free of 7.05 GB) and G (127 MB free of 127 MB). Shouldn't it only have one volume, and if so how can I fix this? I can't delete the volume with Windows Disk Management. Both volumes have a .System folder, if that means anything.
I'd appreciate any help.
Garmin Nüvi 2455 can be cured too, I have updated to the latest software 8.30 with GarminCure3.
NBT EVO Apple CarPlay Full Screen, Navigation, Video in Motion, CP, SSH, full FSC Pack
EntryNav EVO Apple CarPlay, CP, SSH, full FSC Pack
BMW FSC Retrofit CIC/NBT/EVO and FSC for Maps
8HP ISN Reset F Series Remote
Remote VAG Navigation Update, Apple CarPlay and Android Auto
Programming and Coding
Bookmarks