Now i understand your problem. You need to connect usb quickly when holding over the 'G', and then to also start flashing with Updater.exe quickly.
Printable View
Now i understand your problem. You need to connect usb quickly when holding over the 'G', and then to also start flashing with Updater.exe quickly.
The trouble is I don't see a 'G'. The boot logo is gone from flashing 34xx. I try to press both the 40mmx25mm location (the one that worked originally) and the upper left hand corner. I have tried this before pressing power, and 1 and 2 seconds after pressing power. I then immediately insert USB in all these cases. Nothing works, the device just goes into MTP mode.
Edit: It worked! This time I waited until after pressing power, and then immediately press at the 40mmx25mm location (it seems smaller this time), connected USB, hit flash and voila successful!
Now it is saying software loading... should I reboot by long pressing power?
What about flashing Logo Via SD ?
I'm not sure if there is a procedure for this. But I think it's possible somehow !
Real 34xx pre-boot works 100% by the procedure I described earlier.
Yes, it's hard to find the 'G-spot' when there's no 'G'.. lol! That's why i put the 'G' in inverted commas. You'll find it easier when you have flashed the logo. From memory it should reboot itself when the logo flash finishes.
If you flash logo in preboot nuvi stuck and after you press 10 sec power buton your nuvi turn off.
Then press 10 sec power button and your nuvi turn on with logo.
If you flash logo over SD, nuvi restart automaticly, so SD procedure is more easy.
1).drag rgn drop on updater.exeQuote:
Originally Posted by Neil [Only registered and activated users can see links. Click Here To Register...]
2).***connect nuvi-USB-computer***
3).power on nuvi
4).press
6).just notice updater see your nuvi then just click ok.
Easier. ;)) ( compare with connect USB after press)
AekhongQuote:
Originally Posted by aekhong [Only registered and activated users can see links. Click Here To Register...]
Please specify what do you mean by:
Press what?Quote:
4).press
Thanks.
BTW When making transformation 37xx->34xx I prefer flash the whole 34xx firmware with new logo already included. For me it's much more easier.
Press and hold above the "G". You can use the graphic in the OP as a guide to find it.Quote:
Originally Posted by voyager56 [Only registered and activated users can see links. Click Here To Register...]
Yes. Press at specific area to access pre boot mode.
Starting post has been updated with new infos about the failure of "Enable features application" in recent firmwares.
For more infos look [Only registered and activated users can see links. Click Here To Register...]
As usual :
Before converting make your unit files backup and NV backup.
Please read post n1 and follow it with care step by step ,or you can brick your device.
Finally : if you don't know what you are doing .. just don't do it !