Write coordinates of above picture i will look on my nuvi 1300 with FW6.20 if i have the same.
Printable View
Write coordinates of above picture i will look on my nuvi 1300 with FW6.20 if i have the same.
Could you update the file nuvi13xxand14xxseries_GCDFile-MTK__610.gcd again? All the links are dead. Thank you very much.
Some fresh links
Spoiler: CLICK
is it possible to have:
My Nuvi 1300 is in an endless loop boot state.Code:http://www.garmin.com/software/nuvi13xxand14xxseries_regionfileonly__300.gcd
Do you think is possible to unbrick?
Do you want such an old firmware because that's the version on your bricked 1300? If so, you can make the [Only registered and activated users can see links. Click Here To Register...] fw using a later version provided you use the correct original type of firmware, non-MTK or MTK. Check the HWID by using [Only registered and activated users can see links. Click Here To Register...] before you start if you don't know it's hwid for sure. Post in the cure3 thread if you need further help after reading the thread thoroughly, particularly the initial post.
Check HWID before using it like Neil suggested aboveQuote:
Originally Posted by Giobbe [Only registered and activated users can see links. Click Here To Register...]
[Only registered and activated users can see links. Click Here To Register...]
for B1109 use mtk?
13/14xx MTK have B1104
B1109 is for 13xx/14xx Singapore FW:
Spoiler: SG 13xx/14xx FW
1109 is an Asian device ,if I remember well is Sing/Mal
Edit : nuvi13-14xx_SG_v310
[Only registered and activated users can see links. Click Here To Register...]
[Only registered and activated users can see links. Click Here To Register...]
there's no new update then.. its stuck at 310.. sigh..