Try Hard ResetHi to all.
Tried to patch Nuvi 68. All works fine until I save the patched gdc file into rgn format. If I check that XXX01000YYY.rgn file in RGN_Tool again it gives me an error: unsupported section identifier XXX.
When I tried to upload that rgn file trough Garmin Uploader anyway, it starts OK but then it stops and gives me an error, and quits. I think that it hits that unsupported identifier thing (maybe I am wrong). After that the unit was bricked until I used the GarminCure3 and managed to make it reboot again and used Garmin express to go back to original firmware (big thanks to all the experts here for their posts).
The only problem now is that all the images, buttons and icons on this Nuvi 68LM are missing. GPS display is full of little red squares with the words "GIR Mem Low" (no idea what that means) on the background and "Image Not Found" where icons supposed to be. However, touching the screen in the places where buttons should be works fine, just need to guess where to push...
And no, I did not do the backup of NonVol (very stupid of me) and I think that probably is the problem.
Is there any solution to this? After reading hundreds of posts already, I could not find any hints for this problem, but I got an impression that we have some magic workers on this forum.
Any suggestions or can you point me to any possible solutions, please...
Thanks
Try to flash an older version hopefully it will cause a hard reset on first boot.
Bookmarks