Thread: Thailand Streetmap Eng NT+THAI V11.00+JCV+ DEM+ Thailand 3D Building

Eng version work well for me, but thai version doesn't work.

i use on mobile XT, any idea????

Where do I put the JCV file and do I have to rename it? I am using Nuvi 1250 Sg/Mal version. Map is gmapprom.img in Map folder on microSD card. Works fine. I put the JCV file in SD card under Garmin/JCV. Used the original file name JCV110EN.jcv. Is this correct?

How do I check if the JCV is working?

Originally Posted by malebum

Where do I put the JCV file and do I have to rename it? I am using Nuvi 1250 Sg/Mal version. Map is gmapprom.img in Map folder on microSD card. Works fine. I put the JCV file in SD card under Garmin/JCV. Used the original file name JCV110EN.jcv. Is this correct?

How do I check if the JCV is working?

You may try to simulating a route in Bangkok to test JCV.

I tried simulation in Bangkok but did not see any JCV. Is there any junction where there is confirmed JCV so I can test?

Thanks for sharing the map.

I'm using a 255W sg and I loaded the map onto SD card. I travelled from Bangkok -> Rayong -> Chanthaburi -> Trat. The map works well. However, when it goes thru some highway in Bangkok, a message "this is pirating copy" keeps popping up. Also JCV doesn't seen to work. I'm used the original name as posted on first page so not sure if there is any naming convention that I need to stick to.

Originally Posted by sue88

Thanks for sharing the map.

I'm using a 255W sg and I loaded the map onto SD card. I travelled from Bangkok -> Rayong -> Chanthaburi -> Trat. The map works well. However, when it goes thru some highway in Bangkok, a message "this is pirating copy" keeps popping up. Also JCV doesn't seen to work. I'm used the original name as posted on first page so not sure if there is any naming convention that I need to stick to.

Your firmware are over ver.2.8 , if you want to see JCV you have to down your firm ware to be 2.8 to be able to see Thai JCV

Some one has 1460 (thai) firmware 3.00? please share. Thank in advance. Because i want to try convert my 1450 tw to1460 (thai) in order use Thai JCV.

why does v11 file size is smaller than v10.1???