Last edited by smokefree; 1st February 2016 at 11:45 PM. Reason: Merged two consecutive posts.
Kunix cure cannot boot it's made to allow the pc to see the unit, after formatting you must flash original firmware by Updater.exe or within cure software, then run webupdater or Express.
You must flash a HWID 1046 firmware and only that one.
You have to navigate to get to the good.
Galaxy S5 Kitkat 4.4.2 / Nuvi1200->1250 / Nuvi3790T->34xx / Nuvi 2200 / Nuvi 66 / Oregon 600
[Only registered and activated users can see links. ]Code:Please Login or Register to see the links
You have to navigate to get to the good.
Galaxy S5 Kitkat 4.4.2 / Nuvi1200->1250 / Nuvi3790T->34xx / Nuvi 2200 / Nuvi 66 / Oregon 600
After flashing restart nuvi and check if nuvi creates a Garmin folder with garmindevice.xml inside.
If it is not created and if you have a backup copy it in Garmin folder, after that run Webupdater, if you don't have a backup, create the Garmin folder and restart nuvi again, it should create it.
You have to navigate to get to the good.
Galaxy S5 Kitkat 4.4.2 / Nuvi1200->1250 / Nuvi3790T->34xx / Nuvi 2200 / Nuvi 66 / Oregon 600
Hi Catymag,
I did as you said above.
When I flash the original firmware, It created a Garmin folder with GarminDevice.xml inside.
I run the webupdater and It Worked!! Without maps.
Then I installed the maps.
It runs well for a while, but bricked again.
I did everything again and it is working.
But I didnt install all the files of the back up, neither gmapbmap files.
Thank you all!!
Bookmarks