i will try it right now!! brb with update
erm so i had some trouble with my sd card, my pc could not read my sd card tried a few times it worked. erm but how do i add the maps now.. do i make folders like that or do i just copy the one i want right into the map folder of igo primo? yeah i will do only belgium to see if it will work.
Last edited by Wantedgps; 5th May 2016 at 08:04 PM.
So i have tested it just now and i get a error message , global.txt or global_cfg.txt missing. and i can't find it from the downloads i already have.
Last edited by Wantedgps; 5th May 2016 at 10:09 AM.
You have to navigate to get to the good.
[Only registered and activated users can see links. ] Password for my files: gpspower.net
Please don't flood my pm box with questions you can post on forum!! You won't hear back from me.
Galaxy S5 Kitkat 4.4.2 / Nuvi1200->1250 / Nuvi3790T->34xx / Nuvi 2200 / Nuvi 66 / Oregon 600
So i am still getting the same error, i have done it like the original old igo primo that i had. i have downloaded from the link you gave me. the one on my sd card ( G drive )
Last edited by Boki_Srb; 5th May 2016 at 09:39 PM. Reason: spoilers, please
I think your device don't like Primo 2.4 as is using to much resources of your "RNS 510"..Try with Primo 1.2 which is the most stable Primo version from my experience
HTML Code:Please Login or Register to see the links
alright will go try it right now. thanks hope it works.
So good news! it loaded the gps igo primo with the new maps! but than i put random address to test it and it says gps receiver is off , than a option to put it on i press to enable it than its re-calculating the route and still the message is still here before that it keep saying searching for gps satellite , so i click how many are available it says 0... and i dont understand why it needs a satellite if its offline map right
Last edited by Wantedgps; 5th May 2016 at 02:44 PM.
Navigation needs GPS signal to determine your current location. You must wait for the gps signal lock. Usually it takes about 1 min..for the very first time it may take to 5 min..
Mr.Wantedgps, you do not read most carefully everything that is written to you. I've already said:
... If necessary, only in the sys.txt enter values for your gps port and baud rate. ...
Read values from old version of iGO that works.
Also, if you don't find those values, and you have "ordinary" iGO8 at your card, it have option to detect those ports.
SETTINGS > second page > GPS > untick GPS enabled > click on "Autodetect". Use values that are found.
There are some devices, where is no way automatic search for ports to functioning. You have to write them manually.
And, there is no way that this Primo (honda edition) does not work at your device, problem is somewhere else, something is mixed up. It works even at my 9 years old device. Your have DualCore CPU and 128MB RAM.
Use clean mSD card, they are very cheap (<4€ for 8GB). Put only one version of Primo.
Also, you can try Primo 2.0, last and one of the best editions is:
[Only registered and activated users can see links. ]
Link to package:
Inside is global_cfg already, add language and voice files as you wish, and map and poi . Ports are set to auto values. If not helps, again, manually write values in sys.txt.
Anyway, for unit like your, general suggestions is to use Primo 2.4.
Last edited by Boki_Srb; 5th May 2016 at 10:04 PM.